+86 135 9436 7882 info@techcummins.com

Select a Country or Region

English
Technical Articles Technical Articles

Technical Articles

All Articles

  1. Home
  2. News
  3. All Articles
Instructions Before the Cummins Engine Starts

Instructions Before the Cummins Engine Starts

New and Rebuilt Engine Break-in Cummins engines are run-in on dynamometers before being shipped from the factoryandare ready to be put to work in applications such asemergency fire trucks,rail car applications and generator sets. In other applications, th

2022-11-01
The Start of Cummins Engine

The Start of Cummins Engine

Starting requires that clean air and fuel be supplied to the combustion chambers in the proper quantities at the correct time. Normal Starting Procedure Warning: Before starting be sure that everyone is clear of the engine and equipment. If the fuel syste

2022-11-01
Cold Weather Starting for Cummins Engine

Cold Weather Starting for Cummins Engine

Note: A water jacket heater is recommended for stand-by generator set applications installed in a cold climate. Preheater The glow plug system supplies heattothecylinders so that compression temperatures are sufficient to ignite the fuel. To aid in start

2022-11-01
Cummins Engine Warm-Up

Cummins Engine Warm-Up

When the engine is startedit takes a while to get the lubricating oil film re-established between shafts and bearings and between pistons and liners.The most favorable clearances between moving parts are obtained only after all engine parts reach normal o

2022-11-01
Cummins Engine Shut-Down

Cummins Engine Shut-Down

Idle Engine A Few Minutes Before Shut-Down It is important to idle anengine 3to 5minutes before shutting it down to allow the lubricating il and water to carry heat away from thecombustion chamber, bearings, shafts etc.This is especially important with tu

2022-11-01
Cold-Weather Protection for Cummins Engine

Cold-Weather Protection for Cummins Engine

1. For cold-weather operation,use of permanenttype antifreeze with rust inhibitor additives is recommended. See Section3 2. Drain the cylinder block and heads onall engines by opening the petcocks and removing the drain plugs as shown in Fig.'s 1-13 to 1-

2022-11-01

Link

Contact Us

+86 23 67069302
+86 135 9436 7882
WhatsApp: +86 135 9436 7882
info@techcummins.com
Office Add.: Hongyuan Road, Jiangbei District, Chongqing, China
Factory Add.: Jingkou Industrial area, Shapingba District, Chongqing, China

TC Machinery

We are a comprehensive company based on diesel engines, integrating the supply, technical support and service of marine engine, pump engine, mining truck engine, construction machinery engine, diesel generator, marine generator, diesel engine pack, genuine spare parts.

Leave a Message